Sharpen Your Knowledge with Dell EMC (DNDNS-200) Certification Sample Questions
CertsTime has provided you with a sample question set to elevate your knowledge about the Dell EMC Dell Networking Professional exam. With these updated sample questions, you can become quite familiar with the difficulty level and format of the real DNDNS-200 certification test. Try our sample Dell EMC Dell Networking Professional certification practice exam to get a feel for the real exam environment. Our sample practice exam gives you a sense of reality and an idea of the questions on the actual Dell EMC Dell Networking certification exam.
Our sample questions are similar to the Real Dell EMC DNDNS-200 exam questions. The premium Dell EMC Dell Networking Professional certification practice exam gives you a golden opportunity to evaluate and strengthen your preparation with real-time scenario-based questions. Plus, by practicing real-time scenario-based questions, you will run into a variety of challenges that will push you to enhance your knowledge and skills.
Dell EMC DNDNS-200 Sample Questions:
Refer to the exhibit. Based on the deployment diagram, which problem will the deployment engineer experience when trying to deploy this configuration?
A network engineer needs to connect a switch with a 10 G uplink port to an upstream Z-Series switch. The engineer determines that the connection cannot be made with the cabling that was shipped with the Z-Series switch.
Which cabling does the engineer need to make the required connection?
Refer to the exhibit. Which interface can communicate with interface Te 0/5?
Refer to the exhibit.
A network engineer must configure a QSFP port to be broken out on a Dell N-Series switch.
console>enable
console#configure
console(config)#interface Fo1/1/1
console(config-if-Fo1/1/1)#hardware profile portmode 4x10g
console(config-if-Fo1/1/1)#exit
console(config)#wr
Cables have been plugged-in as shown. The network engineer runs the CLI command ''show interfaces status'' and interface Fo1/1/1 shows Detached. What is the most likely reason for this behavior?
Refer to the exhibits. A network engineer has configurations as shown in Figure A and Figure B. However, the port-channel 128 shows in the default VLAN 1 and not in VLANs 10 and 20.
What has the network engineer to change in the configurations to fix the issue?
Exhibit 1.
Exhibit 2.
Note: If there is any error in our Dell EMC DNDNS-200 certification exam sample questions, please update us via email at support@certstime.com.