Sharpen Your Knowledge with Fortinet (NSE7_SAC-6.2) Certification Sample Questions
CertsTime has provided you with a sample question set to elevate your knowledge about the Fortinet NSE 7 - Secure Access 6.2 exam. With these updated sample questions, you can become quite familiar with the difficulty level and format of the real NSE7_SAC-6.2 certification test. Try our sample Fortinet NSE 7 - Secure Access 6.2 certification practice exam to get a feel for the real exam environment. Our sample practice exam gives you a sense of reality and an idea of the questions on the actual Fortinet Certified Solution Specialist certification exam.
Our sample questions are similar to the Real Fortinet NSE7_SAC-6.2 exam questions. The premium Fortinet NSE 7 - Secure Access 6.2 certification practice exam gives you a golden opportunity to evaluate and strengthen your preparation with real-time scenario-based questions. Plus, by practicing real-time scenario-based questions, you will run into a variety of challenges that will push you to enhance your knowledge and skills.
Fortinet NSE7_SAC-6.2 Sample Questions:
Refer to the exhibit.
The exhibit shows two FortiGate devices in active-passive HA mode, including four FortiSwitch devices connected to a ring.
Which two configurations are required to deploy this network topology'' (Choose two.)
Default VLANs are created on FortiGate when the FortiLink interface is created. By default, which VLAN is set as Allowed VLANs on all FortiSwitch ports?
What action does FortiSwitch take when it receives a loop guard data packet (LGDP) that was sent by itself?
Refer to the exhibit.
A host machine connected to port2 on ForitSwitch cannot connect to the network. All ports on FortiSwitch are assigned a security policy to enforce 802.1X port authentication. While troubleshooting the issue, the administrator runs the debug command and obtains the output shown in the exhibit.
Which two scenarios are the likely cause of this issue? (Choose two.)
An administrator is deploying APs that are connecting over an IPsec network. All APs have been configured to connect to FortiGate manually. FortiGate can discover the APs and authorize them. However, FortiGate is unable to establish CAPWAP tunnels to manage the APs.
Which configuration setting can the administrator perform to resolve the problem?
Note: If there is any error in our Fortinet NSE7_SAC-6.2 certification exam sample questions, please update us via email at support@certstime.com.